Burlington Aviation's Maintenance Facility  specializes in repair, maintenance, corrosion protection and aircraft weighing of all light, single and twin piston aircraft. Our IA and A&P staff brings years of expert experience to the maintenance of your aircraft. First we begin with a thorough review of the work to be performed followed by a discussion of the costs and options for the intended service, BEFORE WE START THE WORK. We provide continuous communication with you as your service is being performed.  

We only accept appointments that we can keep and make every effort to have your plane completed as promised. We enjoy reviewing the aircraft with you, discussing its systems, and the special requirements you may have.

Some of the many services and maintenance performed at the Burlington Aviation Maintenance Facility
Annuals	Landing Gear/Tires	Oil Changes	Structural Repairs
Props / Spinners	Instrument Panels	Engine Repair	Pre-Buy Inspections
Aircraft Weighing			Corrosion Protection
>click photos above to enlarge< >use back key to return<
Burlington Aviation Maintenance Facility
Inside Hanger View

Contact Information

• Structural
• Props
• Spinners
• Annuals
• 100 hour
• Oil Changes
• Compass Swings
• Instrument Replaces and Installations
• Landing Gear
• Tires
• Pre-Buy Inspections
• Major/Minor Repairs and Alterations
• Engine Repairs
• Aircraft Weighing
• Corrosion Protection using Corrosion X

The following services are included in our ANNUAL or 100 HOUR inspection flat rates:

1. Removal/installation of panels and cockpit access
2. Inspection of acft per FAR 43, appendix D requirements and/or manufacturer inspection guide
3. Visual AD's (not requiring maintenance to complete them)
4. Oil change labor
5. Cleaning plugs labor
6. Cleaning injector labor
7. Compression check labor
8. All filter element replacement labor
9. Wheel bearing inspection/repack labor
10. Cleaning fuel bowl(s)/ screens labor
11. Landing gear retraction/rig check
12. Service shimmy dampener
13. AD search (provided there is an adequate previous compliance report)
14. Checking cable tensions
15. Testing/Inspecting ELT (annual)
16. Pre and post inspection run-up for systems check
17. New aircraft log portfolio (if needed), set-up by and compliments of Burlington Aviation
18. Battery service and clean
19. Check magneto timing